HAL_ETH_ErrorCallback() function

pointer to a ETH_HandleTypeDef structure that contains the configuration information for ETHERNET module

Read a PHY register

Writes to a PHY register.

Initializes the ETH MSP.

Initialize the Ethernet peripheral registers.

Set the MAC configuration.

Get the configuration of the MAC and MTL subsystems.

Enables Ethernet MAC and DMA reception and transmission

Stop Ethernet MAC and DMA reception/transmission

Read a received packet.

Configures the Clock range of ETH MDIO interface.

This function handles ETH interrupt request.

Rx Transfer completed callbacks.

Enables Ethernet MAC and DMA reception/transmission in Interrupt mode

Sends an Ethernet Packet in polling mode.

Tx Transfer completed callbacks.

DeInitializes ETH MSP.

Release transmitted Tx packets.

Sends an Ethernet Packet in interrupt mode.

Stop Ethernet MAC and DMA reception/transmission in Interrupt mode

Returns the ETH DMA error code

Initializes the DMA Tx descriptors in chain mode.

Initializes the DMA Rx descriptors in chain mode.

Sends an Ethernet frame.

Gets the Received frame in interrupt mode.

Set ETH MAC Configuration.

Configures Ethernet MAC and DMA with default parameters.

Clears the ETHERNET transmit FIFO.

This function gives back Rx Desc of the last received Packet to the DMA, so ETH DMA will be able to use these descriptors to receive next Packets.

Set the ETH MAC (L2) Filters configuration.

Returns the ETH state.

DeInitializes the ETH peripheral.

Prepare Tx DMA descriptor before transmission. called by HAL_ETH_Transmit_IT and HAL_ETH_Transmit_IT() API.

Clears the ETHERNET transmit FIFO.

Set the ETH DMA configuration.

Ethernet Power Management module IT callback

ETH WAKEUP interrupt callback

Configures Ethernet MAC and DMA with default parameters. called by HAL_ETH_Init() API.

Configures the selected MAC address.

Initializes the DMA Tx descriptors. called by HAL_ETH_Init() API.

Initializes the DMA Rx descriptors in chain mode. called by HAL_ETH_Init() API.

Enables the MAC transmission.

Disables the MAC transmission.

Enables the MAC reception.

Disables the MAC reception.

Enables the DMA transmission.

Disables the DMA transmission.

Enables the DMA reception.

Disables the DMA reception.

Configures the selected MAC address.

Returns the ETH MAC WakeUp event source

Register the Rx alloc callback.

Unregister the Rx alloc callback.

Set the Rx link data function.

Unregister the Rx link callback.

Get the error state of the last received packet.

Set the Tx free function.

Unregister the Tx free callback.

Set the VLAN Identifier for Rx packets

Get the ETH MAC (L2) Filters configuration.

Set the ETH Hash Table Value.

Set the source MAC Address to be matched.

Enters the Power down mode.

Exits from the Power down mode.

Set the WakeUp filter.

Returns the ETH error code

Returns the ETH MAC error code

Get the configuration of the DMA.

Checks for received frames.

Sets ETH DMA Configuration.