rmt_ll_get_rx_err_interrupt_status() function

Enable RMT interrupt for specific event mask

Clear RMT interrupt status by mask

Reset RMT writing pointer for RX channel

Reset RMT reading pointer for TX channel

Enable receiving for RX channel

Set RMT memory owner for RX channel

Enable transmitting in a loop

Fix the output level when TX channel is in IDLE state

Enable modulating carrier signal to TX channel

Set on high or low to modulate the carrier signal

Set clock source and divider for RMT channel group

Enable RMT peripheral source clock

Set TX channel clock divider

Force power off the RMT memory block, regardless of the outside PMU logic

Power control the RMT memory block by the outside PMU logic

Set high and low duration of carrier signal

Set RX channel clock divider

Set memory block number for TX channel

Set RX channel filter threshold (i.e. the maximum width of one pulse signal that would be treated as a noise)

Set memory block number for RX channel

Set the time length for RX channel before going into IDLE state

Enable filter for RX channel

Enable APB accessing RMT memory in nonfifo mode

Enable TX wrap

Set the amount of RMT symbols that can trigger the limitation interrupt

Start transmitting for TX channel

Get RMT memory write cursor offset

Get interrupt status register address

Reset clock divider for TX channels by mask

Reset clock divider for RX channels by mask

Get interrupt status for TX channel

Get interrupt raw status for TX channel

Get interrupt raw status for RX channel

Get interrupt status for RX channel

Enable clock gate for register and memory

Force power on the RMT memory block, regardless of the outside PMU logic