mwdt_ll_set_edge_intr() function

Start address of the peripheral registers.

Whether to enable edge interrupt

Enable alarm event

Enable timer, start counting

Enable timer interrupt by mask

Clear interrupt status by mask

Enable auto-reload mode

Enable Timer Group (GPTimer) module clock

Get interrupt status

Disable a particular stage of the MWDT

Feed the MWDT Resets the current timer count and current stage.

Get counter value

Set alarm value

Set reload value

Set clock prescale for timer

Set count direction

Disable write protection of the MWDT registers

Clear the MWDT interrupt status.

Enable write protection of the MWDT registers

Disable the MWDT

Set clock source for timer

Trigger software capture event

Get interrupt status register address.

Set the interrupt enable bit for the MWDT interrupt.

Enable MWDT module clock

Get reload value

Trigger software reload, value set by `timer_ll_set_reload_value()` will be reflected into counter immediately

Set the clock source for the MWDT.

Enable or disable MWDT level interrupt

Set the length of the CPU reset action

Set the length of the system reset action

Enable/Disable the MWDT flashboot mode.

Set the clock prescaler of the MWDT

Enable the MWDT

Check if the MWDT is enabled

Configure a particular stage of the MWDT

Enable the register clock forever