IDD_ConfigTypeDef struct

Specifies ampli gain value.

Specifies minimum MCU VDD can reach to protect MCU from reset.

Specifies value of Shunt 0 if existing.

Specifies value of Shunt 1 if existing.

Specifies value of Shunt 2 if existing.

Specifies value of Shunt 3 if existing.

Specifies value of Shunt 4 if existing.

Specifies delay of Shunt 0 stabilization if existing.

Specifies delay of Shunt 1 stabilization if existing.

Specifies delay of Shunt 2 stabilization if existing.

Specifies delay of Shunt 3 stabilization if existing.

Specifies delay of Shunt 4 stabilization if existing.

Specifies number of shunts that are present on board This parameter can be a value of IDD_shunt_number.

Specifies number of shunts used for measurement This parameter can be a value of IDD_shunt_number.

Specifies if Vref is automatically measured before each Idd measurement This parameter can be a value of IDD_Vref_Measurement.

Specifies if calibration is done before each Idd measurement.

Specifies Pre delay unit This parameter can be a value of IDD_PreDelay.

Specifies Pre delay value in selected unit.

Specifies number of Measure to be performed This parameter can be a value between 1 and 256.

Specifies Delta delay unit This parameter can be a value of IDD_DeltaDelay.

Specifies Delta delay between 2 measures value can be between 1 and 128.