s_i2c_start_end_command() function

I2C master handle

Pointer to I2C trans operation structure.

I2C device address with read or write information.

Add I2C master BUS device.

Allocate an I2C master bus

Reset I2C hardware fsm. 1. Store filter and timing stuff(they are I2C hardware configure stuff) so, the configuration is same after reset.

Create LCD panel IO handle, for I2C interface in new implementation

This function is used to send I2C read command, which is divided in three parts. -1. If read buffer is smaller than hardware fifo, it can be sent out in one single time, so the hardware command(step) is simply like start(1)->read_ack(2)->read_nack(3)->end(4) -2. If read buffer is larger than hardware fifo, it cannot be sent out in one time, so it needs to be separated in to different transactions by interrupt. In this time, the hardware command(step) simply looks like start(1)->read_part(2)--interrupt--...--read(1)->end(2). -3. If only one byte is waiting to be read. only send nack command. like start(1)->read_nack(2)->end(3)

Deinitialize the I2C master bus and delete the handle.

Probe I2C address, if address is correct and ACK is received, this function will return ESP_OK. @attention Pull-ups must be connected to the SCL and SDA pins when this function is called. If you get `ESP_ERR_TIMEOUT while `xfer_timeout_ms` was parsed correctly, you should check the pull-up resistors. If you do not have proper resistors nearby. `flags.enable_internal_pullup` is also acceptable.

This function is used to send I2C write command, which is divided in two parts. -1. If write buffer is smaller than hardware fifo, it can be sent out in one single time, so the hardware command(step) is simply like start(1)->write(2)->end(3) -2. If write buffer is larger than hardware fifo, it cannot be sent out in one time, so it needs to be separated in to different transactions by interrupt. In this time, the hardware command(step) simply looks like start(1)->write_part(2)--interrupt--...--write(1)->end(2).

Wait for all pending I2C transactions done

Reset the I2C master bus.

Retrieves the I2C master bus handle for a specified I2C port number. This function retrieves the I2C master bus handle for the given I2C port number. Please make sure the handle has already been initialized, and this function would simply returns the existing handle. Note that the returned handle still can't be used concurrently