example_wifi_sta_do_connect() function

Set the configuration of the STA, AP or NAN @attention 1. This API can be called only when specified interface is enabled, otherwise, API fail @attention 2. For station configuration, bssid_set needs to be 0; and it needs to be 1 only when users need to check the MAC address of the AP. @attention 3. ESP devices are limited to only one channel, so when in the soft-AP+station mode, the soft-AP will adjust its channel automatically to be the same as the channel of the station. @attention 4. The configuration will be stored in NVS for station and soft-AP

Get configuration of specified interface

Set a specified parent for the device @attention This API can be called at any time after mesh is configured.

Runs Wi-Fi as Station with the supplied configuration Configures the Wi-Fi station mode to connect to the AP with SSID and password specified in config structure and sets Wi-Fi to run as station. This is automatically called by provisioning service upon receiving new credentials. If credentials are to be supplied to the manager via a different mode other than through protocomm, then this API needs to be called. Event WIFI_PROV_CRED_RECV is emitted after credentials have been applied and Wi-Fi station started