esp_zb_zcl_metering_status_water_t is only used within esp_zigbee_gateway sample.
Symbols ![]()
loading...
Files ![]()
loading...
esp_zb_zcl_metering_status_water_t enum
Syntax
enum
{
ESP_ZB_ZCL_METERING_WATER_CHECK_METER = 1 << 0,
ESP_ZB_ZCL_METERING_WATER_LOW_BATTERY = 1 << 1,
ESP_ZB_ZCL_METERING_WATER_TAMPER_DETECT = 1 << 2,
ESP_ZB_ZCL_METERING_WATER_PIPE_EMTPY = 1 << 3,
ESP_ZB_ZCL_METERING_WATER_LOW_PRESSURE = 1 << 4,
ESP_ZB_ZCL_METERING_WATER_LEAK_DETECT = 1 << 5,
ESP_ZB_ZCL_METERING_WATER_SERVICE_DISCONNECT = 1 << 6,
ESP_ZB_ZCL_METERING_WATER_REVERSE_FLOW = 1 << 7
};
Values
Value
Declared as
Description
= 1 << 0
CheckMeter bit is Set to true when a non fatal problem has been detected on the meter.
= 1 << 1
LowBattery bit is set to true when the battery needs maintenance.
= 1 << 2
TamperDetect bit set to true if a tamper event has been detected.
= 1 << 3
PipeEmpty bit is set to true when the service pipe at the meter is empty and there is no flow in either direction.
= 1 << 4
LowPressure bit is Set to true when the pressure at the meter is below the meter's low pressure threshold value.
= 1 << 5
LeakDetect bit is set to true when a leak has been detected.
= 1 << 6
ServiceDisconnect bit is set to true when the service has been disconnected to this premises.
= 1 << 7
ReverseFlow bit is Set to true if flow detected in the opposite direction to normal (from consumer to supplier).