esp_zb_zcl_metering_status_gas_t enum

Syntax

Show:

Summary

Declaration

enum { ESP_ZB_ZCL_METERING_GAS_CHECK_METER = 1 << 0, ESP_ZB_ZCL_METERING_GAS_LOW_BATTERY = 1 << 1, ESP_ZB_ZCL_METERING_GAS_TAMPER_DETECT = 1 << 2, ESP_ZB_ZCL_METERING_GAS_RESERVED = 1 << 3, ESP_ZB_ZCL_METERING_GAS_LOW_PRESSURE = 1 << 4, ESP_ZB_ZCL_METERING_GAS_LEAK_DETECT = 1 << 5, ESP_ZB_ZCL_METERING_GAS_SERVICE_DISCONNECT = 1 << 6, ESP_ZB_ZCL_METERING_GAS_REVERSE_FLOW = 1 << 7 };

Value

Declared as

Description

= 1 << 0

CheckMeter bit is Set to true when a non fatal problem has been detected on the meter.

= 1 << 1

LowBattery bit is set to true when the battery needs maintenance.

= 1 << 2

TamperDetect bit is set to true if a tamper event has been detected.

= 1 << 3

Reserved bit.

= 1 << 4

LowPressure bit is set to true when the pressure at the meter is below the meter's low pressure threshold value.

= 1 << 5

LeakDetect bit is set to true when a leak has been detected.

= 1 << 6

ServiceDisconnect bit is set to true when the service has been disconnected to this premises.

= 1 << 7

ReverseFlow bit is set to true if flow detected in the opposite direction to normal (from consumer to supplier).

from examples