esp_zb_zcl_metering_status_electricity_t enum

Syntax

Show:

Summary

Declaration

enum { ESP_ZB_ZCL_METERING_ELECTRICITY_CHECK_METER = 1 << 0, ESP_ZB_ZCL_METERING_ELECTRICITY_LOW_BATTERY = 1 << 1, ESP_ZB_ZCL_METERING_ELECTRICITY_TAMPER_DETECT = 1 << 2, ESP_ZB_ZCL_METERING_ELECTRICITY_POWER_FAILURE = 1 << 3, ESP_ZB_ZCL_METERING_ELECTRICITY_POWER_QUALITY = 1 << 4, ESP_ZB_ZCL_METERING_ELECTRICITY_LEAK_DETECT = 1 << 5, ESP_ZB_ZCL_METERING_ELECTRICITY_SERVICE_DISCONNECT_OPEN = 1 << 6, ESP_ZB_ZCL_METERING_ELECTRICITY_RESERVED = 1 << 7 };

Value

Declared as

Description

= 1 << 0

CheckMeter bit is set to true when a non fatal problem has been detected on the meter.

= 1 << 1

LowBattery bit is set to true when the battery needs maintenance.

= 1 << 2

TamperDetect bit is set to true if a tamper event has been detected.

= 1 << 3

PowerFailure bit is set to true during a power outage.

= 1 << 4

PowerQuality bit is set to true if a power quality event has been detected such as a low voltage, high voltage.

= 1 << 5

LeakDetect bit is set to true when a leak has been detected.

= 1 << 6

ServiceDisconnectOpen bit is Set to true when the service has been disconnected to this premises.

= 1 << 7

Reserved bit.

from examples